OT: Twinkle cli

[Derek Roberts]

Hi,

I'm trying to call 3000 at linux-speakup.org with sflphone, but it says
502 - Bad Gateway and gives a busy signal. What's up?

Thanks.

On 1/28/11, Igor Gueths <igueths at lava-net.com> wrote:
> Well, in SIP, the thing you really have to worry about most is the IP
> information that is contained within the packet's payload itself, since that
> is
> really the deciding factor in call negotiation. Basically what would happen
> in
> these nstances is that in Twinkle's twinkle.log file, I'd see packets going
> from
> my laptop (192.168.1.44), back to 192.168.1.44 even though my Asterisk I was
> trying to reach is at 192.168.1.43. For this reason, even though at the
> Twinkle
> CLI I'd type call sip:300 at 192.168.1.43 (a test extension I have here), I
> just
> get put back at a "twinkle>" prompt with no discernible activity occurring
> at
> the console.
> On Fri, Jan 28, 2011 at 01:33:27PM -0500, Kitty Litter wrote:
>> I am trying to learn more about the sip protocol and started using
>> tcpdump. Could you tell me what options you use? It isn't alwalys
>> clear to me the source and destination of the packets, I use -A and
>> -t and -c count.
>>
>> _______________________________________________
>> Speakup mailing list
>> Speakup at braille.uwo.ca
>> http://speech.braille.uwo.ca/mailman/listinfo/speakup
>>
>> --
>> This message has been scanned for viruses and
>> dangerous content by MailScanner, and is
>> believed to be clean.
>>
>
> --
> Igor
>
> --
> This message has been scanned for viruses and
> dangerous content by MailScanner, and is
> believed to be clean.
>
> _______________________________________________
> Speakup mailing list
> Speakup at braille.uwo.ca
> http://speech.braille.uwo.ca/mailman/listinfo/speakup
>