First build

Glenn Ervin GlennErvin at cableone.net
Tue Nov 4 21:08:42 EST 2008


Hi,
I have found that you swing the locking lever out a bit, away from the 
processor, and down and back to lock it down
Last processor I put in was a 1.4 MHZ P4.  A couple of years ago.
When removing a processor, take note of the corners, as one looks like it 
was chopped off.
This will help you put it back correctly.
HTH.
Glenn
----- Original Message ----- 
From: "John G. Heim" <jheim at math.wisc.edu>
To: "Speakup is a screen review system for Linux." <speakup at braille.uwo.ca>
Sent: Tuesday, November 04, 2008 10:41 AM
Subject: Re: First build


I believe I asked exactly the same question about a year ago on this list.
Turns out I was just being timid. Yeah, you have to press down on that lever
pretty hard.  But I did get an experienced,  sighted person to make sure
everything was correct before I did it.  I just wasn't brave enough to try
it on my own. I didn't want to have to explain to my wife that I was going
to have to spend another 100 bucks on a mobo or cpu.

And like you, it took me a while to figure out that the heat sync was
pre-glued.  I touched it before I figured it out. That's kind of bad but
what can you do? The machine is still working a year later and I do not
think I've turned it off that whole time. So if you touched that sticky part
on the heat sync, I wouldn't worry about it.


----- Original Message ----- 
From: "Rob" <kyrath at cox.net>
To: "Speakup" <speakup at braille.uwo.ca>
Sent: Friday, October 31, 2008 9:07 AM
Subject: First build


> Hi all,
>
> I know several of you build your own systems.  I'm attempting to build my
> first system and have a couple of questions.
>
> I'm working with an Intel DP35DPM board and a e8400 dual core processor.
>
> I finally figured out that my heatsink/fan has a pre-applied thermal pad.
> So I was attempting to install the processor last night.  The processor
> seems to seat properly, but the socket plate does not seat fully.  It
> appears that it would require excessive force to secure the socket lever.
> I'm afraid of cracking or damaging the processor/socket.  Is it normal to
> require significant force to latch the socket closed?
>
> I reexamined the socket plate without the processor in there and it does
> feel like the middle of the plate dips down a little, which would explain
> why the plate is sitting flush at the back end and raised at the front
> when the processor is in the socket.  Again, is it normal for the socket
> plate to have that slightly concave contour?
>
> Thanks for any advice/guidance in advance.
>
> -- Rob
>
> _______________________________________________
> Speakup mailing list
> Speakup at braille.uwo.ca
> http://speech.braille.uwo.ca/mailman/listinfo/speakup
>
>

_______________________________________________
Speakup mailing list
Speakup at braille.uwo.ca
http://speech.braille.uwo.ca/mailman/listinfo/speakup




E-mail message checked by Spyware Doctor (5.5.1.322)
Database version: 5.11050e
http://www.pctools.com/en/spyware-doctor/ 





E-mail message checked by Spyware Doctor (5.5.1.322)
Database version: 5.11050e
http://www.pctools.com/en/spyware-doctor/



More information about the Speakup mailing list