dectalk question

[Alex Snow]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

this isn't the express. it's the original dectalk. uses the decext 
driver.
On Tue, Jun 15, 2004 at 06:47:28PM -0400, Jayson Smith wrote:
> The Dectalk Express is set up to receive data sent at 9600 baud, 8 data
> bits, 1 stop bit, and no parity.  I'd assume that's what Speakup would
> probably expect.  At any rate, that would be a good starting point.
> Jayson.
> 
> ----- Original Message -----
> From: "Alex Snow" <alex_snow at gmx.net>
> To: "Speakup list" <speakup at braille.uwo.ca>
> Sent: Tuesday, June 15, 2004 4:50 PM
> Subject: dectalk question
> 
> 
> > -----BEGIN PGP SIGNED MESSAGE-----
> > Hash: SHA1
> >
> > Hi all. I finally got into the setup interface of my dtc01 to see if I
> > can get it to run with speakup. What com parameters does speakup expect
> > from the dectalk? I'm asuming the parameters for the "host" are what I
> > should change. like the default baud is 1200. is this what speakup
> > expects?
> >
> > - --
> > Linux is addictive, I'm hooked!
> > -- MaDsen Wikholm's .sig
> > -----BEGIN PGP SIGNATURE-----
> > Version: GnuPG v1.2.3 (GNU/Linux)
> >
> > iD8DBQFAz2El9XVrM3ri110RAi61AJ0QOS1trMCRWx4e/yEGNwue+UWH2gCbBMBJ
> > xUMTZpoKoAMw27ktuyt5tiU=
> > =CC91
> > -----END PGP SIGNATURE-----
> >
> > _______________________________________________
> > Speakup mailing list
> > Speakup at braille.uwo.ca
> > http://speech.braille.uwo.ca/mailman/listinfo/speakup
> >
> 
> 
> _______________________________________________
> Speakup mailing list
> Speakup at braille.uwo.ca
> http://speech.braille.uwo.ca/mailman/listinfo/speakup

- -- 
... faster BogoMIPS calculations (yes, it now boots 2 seconds faster than
it used to: we're considering changing the name from "Linux" to "InstaBOOT"
	-- Linus, in the announcement for 1.3.26
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.3 (GNU/Linux)

iD8DBQFAz6Fk9XVrM3ri110RAtgNAJ9KPH3ntzaPZmeyHo0jfjtHBWTCfQCfdah8
SbnF3U43/gg4HXbSuDs4BMI=
=be1v
-----END PGP SIGNATURE-----