dectalk question

[Jayson Smith]

The Dectalk Express is set up to receive data sent at 9600 baud, 8 data
bits, 1 stop bit, and no parity.  I'd assume that's what Speakup would
probably expect.  At any rate, that would be a good starting point.
Jayson.

----- Original Message -----
From: "Alex Snow" <alex_snow at gmx.net>
To: "Speakup list" <speakup at braille.uwo.ca>
Sent: Tuesday, June 15, 2004 4:50 PM
Subject: dectalk question


> -----BEGIN PGP SIGNED MESSAGE-----
> Hash: SHA1
>
> Hi all. I finally got into the setup interface of my dtc01 to see if I
> can get it to run with speakup. What com parameters does speakup expect
> from the dectalk? I'm asuming the parameters for the "host" are what I
> should change. like the default baud is 1200. is this what speakup
> expects?
>
> - --
> Linux is addictive, I'm hooked!
> -- MaDsen Wikholm's .sig
> -----BEGIN PGP SIGNATURE-----
> Version: GnuPG v1.2.3 (GNU/Linux)
>
> iD8DBQFAz2El9XVrM3ri110RAi61AJ0QOS1trMCRWx4e/yEGNwue+UWH2gCbBMBJ
> xUMTZpoKoAMw27ktuyt5tiU=
> =CC91
> -----END PGP SIGNATURE-----
>
> _______________________________________________
> Speakup mailing list
> Speakup at braille.uwo.ca
> http://speech.braille.uwo.ca/mailman/listinfo/speakup
>