cdrom/cdr trouble or ide1 problem: BIG TROUBLE I think

[Kerry Hoath]

Your kernel mustn't have the necessary support
compiled in or as modules. If you have them as modules you probably
need to add aliases to the module configuration file or compile
in ide-scsi emulation scsi support and generic scsi support.

Regards, Kerry.
On Mon, May 27, 2002 at 12:30:01PM -0500, Cheryl Homiak wrote:
> Well, thanks, Kerry, but this is a case of something that was working and
> suddenly stopped. So it can't be a matter of wrong jumpering, since it's been
> working fine (both of them have been0 for a good month. something could have
> happened to the cable I would imagine, but it isn't a matter of it having been
> put in wrong as it has been working fine and suddenly quit. as I said before,
> the drawer will open on the cdr but not the cdrom. But when I try to mount
> either one, I'm told "not a valid block device". I get "no such file or
> directory: unable to open scsi driver" when I try cdrecord --scanbus.  also, if
> I just tryrunning cdrecord anywy
> , I get something about not being able to open "pg0" which must means it's
> looking for a default type of cdr or something because it should be sg0 not pg0.
> Nobody has opened this machine or changed cables to cause this failure to occur
> and it happened verysuddenly.
> 
> Cheryl
> 
> 
> _______________________________________________
> Speakup mailing list
> Speakup at braille.uwo.ca
> http://speech.braille.uwo.ca/mailman/listinfo/speakup
> 

-- 
Kerry Hoath:  kerry at gotss.net kerry at gotss.eu.org or  kerry at gotss.spice.net.au
ICQ: 8226547 msn: kerry at gotss.net Yahoo: kerryhoath at yahoo.com.au