Does the read-all command exist for software speech?

[Willem van der Walt]

Thanks for the clarification.
Kind regards, Willem


On Wed, 13 Nov 2013, Kirk Reiser wrote:

> Hi Willem: Currently the speakup_soft module can't read index marks
> returned from the connected soft synth even if they did produce them. I
> know espeakup doesn't produce them but I'm not sure about
> speech-dispatcher. So it could be done but not without a fair chunk of
> work by some developer.
>
> On Wed, 13 Nov 2013, Willem van der Walt wrote:
>
>> I know that a number of years ago there were a read-all command, activated 
>> by pressing speakup-r, under development.
>> Is it possible to make this work for software speech?
>> TIA, Willem
>> 
>> _______________________________________________
>> Speakup mailing list
>> Speakup at linux-speakup.org
>> http://linux-speakup.org/cgi-bin/mailman/listinfo/speakup
>> 
>
> -- 
> Well that's it then, colour me gone!
> _______________________________________________
> Speakup mailing list
> Speakup at linux-speakup.org
> http://linux-speakup.org/cgi-bin/mailman/listinfo/speakup
>
> -- 
> This message is subject to the CSIR's copyright terms and conditions, e-mail 
> legal notice, and implemented Open Document Format (ODF) standard. The full 
> disclaimer details can be found at http://www.csir.co.za/disclaimer.html.
>
> This message has been scanned for viruses and dangerous content by 
> MailScanner, and is believed to be clean.
>
> Please consider the environment before printing this email.
>
>