Trouble with speech dispatcher.

[Willem van der Walt]

You should extract speech-dispatcher, change to its directory, do 
./configure&&make&&make install
Note the punctuation in the line above.  You also need speechd-up which 
you can also get where you got speech-dispatcher.
I think it also requires dotconf.
HTH
Willem


On Wed, 17 May 2006, Satyam wrote:

> Dear all,
> I installed speakup modified Fc3 and planning to use speakup using
> software synth. As per the instructions given in the howto install
> speakup guide I downloaded speech dispatcher 0.6 and
> festival-freebsoft-utils-0.6 After careful reading the install document
> of speech dispatcher I issued the command
> Make all
> Then I am getting the following error: No rule to make target all.stop
> What is the cause for this message and how to rectify it.
> Hope to hear from you.
> Satyam.
>
>
>
> -- 
> No virus found in this outgoing message.
> Checked by AVG Free Edition.
> Version: 7.1.385 / Virus Database: 268.6.0/341 - Release Date: 5/16/2006
>
>
>
> _______________________________________________
> Speakup mailing list
> Speakup at braille.uwo.ca
> http://speech.braille.uwo.ca/mailman/listinfo/speakup
>

-- 
This message is subject to the CSIR's copyright, terms and conditions and
e-mail legal notice. Views expressed herein do not necessarily represent the
views of the CSIR.
 
CSIR E-mail Legal Notice
http://mail.csir.co.za/CSIR_eMail_Legal_Notice.html 
 
CSIR Copyright, Terms and Conditions
http://mail.csir.co.za/CSIR_Copyright.html 
 
For electronic copies of the CSIR Copyright, Terms and Conditions and the CSIR
Legal Notice send a blank message with REQUEST LEGAL in the subject line to
HelpDesk at csir.co.za.


This message has been scanned for viruses and dangerous content by MailScanner, 
and is believed to be clean.  MailScanner thanks Transtec Computers for their support.