telling speakup to use ttyS1

[Tyler Littlefield]

He's telling you to pass that as a parameter to the kernel I believe. As
he's speaking about the boot loader.
That would probably be better...
Have you tried it this way?
~~TheCreator~~
website:
http://tysplace.shaned.net
msn:
compgeek134 at hotmail.com
aim:
st8amnd2005
skype:
st8amnd127
moo coder/wizard and administrator

----- Original Message ----- 
From: "John Heim" <jheim at math.wisc.edu>
To: "Speakup is a screen review system for Linux." <speakup at braille.uwo.ca>
Sent: Wednesday, July 26, 2006 1:58 PM
Subject: Re: telling speakup to use ttyS1


> Is this in answer to my question about setting speakup to use ttyS1 at
> the command line? I'm not sure because the subject line is similar but
> not the same.  I specifically was asking if it can be set at the command
> line because setting the speakup parameters in the bootloader config
> hangs my system.
>
> Although, maybe you're saying I cant set speakup_ser via a boot
> parameter, leave out speakup_synth,  and then later initialize the synth
> at the command line.  Is that what you're saying?
>
> I tried it. It didn't work. Although, maybe it is supposed to work and
> my computer is messed  up.
>
>
>
> Joshua Lambert said the following on 7/24/2006 3:43 PM:
> > In your boot loader, you need to pass the location of your serial port
to
> > speakup if you explicitly want ttyS1.
> > speakup_ser=ttyS1
> > Would do it from the get go.
> > You will have to read the docs for your boot loader to figure out how to
> > pass parameters to the kernel command line.
> > hth
> > Josh
> >
> >
> > _______________________________________________
> > Speakup mailing list
> > Speakup at braille.uwo.ca
> > http://speech.braille.uwo.ca/mailman/listinfo/speakup
>
> -- 
> --
> John Heim
> 263-4189 / jheim at math.wisc.edu / http://www.math.wisc.edu/~jheim/
>
> _______________________________________________
> Speakup mailing list
> Speakup at braille.uwo.ca
> http://speech.braille.uwo.ca/mailman/listinfo/speakup