Speakup with artic txprt driver?

[Al Puzzuoli]

Interesting.  I don't even hink I have those settings.  My transport is a 
model 615 version 1.5.  Maybe they had newer firmware revisions or 
something?

Do these settings come up if you turn on the transport while holding down 
the mode button, or can they be accessed via a command line utility?

Thanks,


----- Original Message ----- 
From: "Glenn at home" <GlennErvin at cableone.net>
To: "Speakup is a screen review system for Linux." <speakup at braille.uwo.ca>
Sent: Sunday, July 10, 2005 2:36 PM
Subject: Re: Speakup with artic txprt driver?


>I do, or did just recently, and it works fine.
> Maybe it is not set to "transport mode" in the menus of the transport.
> There are 3 modes, I think are:
> Standby, Transport, and mirror.
> HTH.
> Glenn
> ----- Original Message ----- 
> From: "Al Puzzuoli" <alpuzz at comcast.net>
> To: "Speakup List" <speakup at braille.uwo.ca>
> Sent: Sunday, July 10, 2005 12:37 PM
> Subject: Speakup with artic txprt driver?
>
>
> Hi,
> Does anyone else use the Artic transport with speakup?  I've noticed that
> for some reason, the transport doesn't initialize reliably if I use the
> txprt driver but does initialize with the acntsa.  I would think that the
> txprt driver would provide better control over voice parameters, so would
> like to use it if possible
>
> Any info would be much appreciated.
>
> thanks,
>
> --Al
> _______________________________________________
> Speakup mailing list
> Speakup at braille.uwo.ca
> http://speech.braille.uwo.ca/mailman/listinfo/speakup
>
>
>
> _______________________________________________
> Speakup mailing list
> Speakup at braille.uwo.ca
> http://speech.braille.uwo.ca/mailman/listinfo/speakup
>