Dell laptops and ACPI
Stephen Clower
steve at steve-audio.net
Mon Jul 19 19:47:17 EDT 2004
Igor,
On my laptop, I use the APM module instead. I can shut the lid when the unit is on battery power and off it goes. Opening the lid again brings me back to where I was within just a couple of seconds. Doing this doesn't hurt system performance in any way.
*********** REPLY SEPARATOR ***********
On 7/19/2004 at 6:47 PM Igor Gueths wrote:
>-----BEGIN PGP SIGNED MESSAGE-----
>Hash: SHA1
>
>Hi all. I was finally able to get Slackware-10 installed and working on my
>laptop. The only problem I have found with it however is that I haven't
>found a suitable ACPI state from which the
>system will cleanly recover from. When the machine comes out of S3, I lose
>my Speakup review keys. In some cases, there's also a noticable lag, which
>is normally replicated during high load
>averages or significant disk I/O. I also tried S1, however I couldn't get
>the system out of S1 and back to a normalized state. Anyone know how to
>get an Inspiron600M out of S1? I attempted
>hitting the power button as I did in S3 to wake the system up, however the
>machine seemed to be stuck in S1. The only sollution I have found thus far
>is to reboot, which defeats the purpose of
>ACPI...Anyone have any other ideas/suggestions? Thanks!
>- --
>Failure is not an option, it comes bundled with your Microsoft product.
>-----BEGIN PGP SIGNATURE-----
>Version: GnuPG v1.2.3 (GNU/Linux)
>
>iD8DBQFA/E+JNohoaf1zXJMRAoiEAJ41MPEvtrIm1QtIZYCBW+GO7V045ACghE8E
>PVxgY1HRn9J3aw4cuPxfUmk=
>=uF1N
>-----END PGP SIGNATURE-----
>
>_______________________________________________
>Speakup mailing list
>Speakup at braille.uwo.ca
>http://speech.braille.uwo.ca/mailman/listinfo/speakup
Stephen Clower, that guy from the south.
You can reach me by any of the following:
E-Mail: steve at steve-audio.net
MSN: steve at steve-audio.net
AIM: AudioRabbit03
You can also check out my little home on the web by visiting http://www.steve-audio.net
More information about the Speakup
mailing list