question

[Igor Gueths]

Hi. Well interestingly enough, when I do a lsmod, there are no modules listed. But when the kernel is booting, it tells me the driver version and all the information regarding the card itself such as mac address. So I believe that this means that the driver is in the kernel? I believe this is so, however for some reason the tulip driver might not be loading? 
----- Original Message ----- 
From: Georgina <gena at gena-j.net>
To: <speakup at braille.uwo.ca>
Sent: Saturday, March 16, 2002 9:56 AM
Subject: Re: question 


> Hi
> 
> Sorry forgot try "man interfaces"
> 
> Gena
> 
> 
> 
> >Hi all. I finally got my kernel to boot, and after doing a make =
> >oldconfig and editing .config to answer y to tulip support, the kernel =
> >boots. It probes my ethernet card and calls it eth0. It also displays =
> >its mac address and finds it on irq 10. However, the problem is that =
> >when I check dev to make sure eth0 is present, it isn't there. Why would =
> >the device not be initialized into a device file if it was probed =
> >successfully? This doesn't really make sense to me, considering that =
> >everything went ok. And naturally, I couldn't do ifconfig dhcp because =
> >it didn't find the network interface? How could I go about fixing this =
> >problem? Thanks in advance!=20
> >
> >
> >_________________________________________________________
> >Do You Yahoo!?
> >Get your free @yahoo.com address at http://mail.yahoo.com
> >
> >
> >_______________________________________________
> >Speakup mailing list
> >Speakup at braille.uwo.ca
> >http://speech.braille.uwo.ca/mailman/listinfo/speakup
> 
> _______________________________________________
> Speakup mailing list
> Speakup at braille.uwo.ca
> http://speech.braille.uwo.ca/mailman/listinfo/speakup


_________________________________________________________
Do You Yahoo!?
Get your free @yahoo.com address at http://mail.yahoo.com