question

[Georgina]

Hi

Sorry forgot try "man interfaces"

Gena



>Hi all. I finally got my kernel to boot, and after doing a make =
>oldconfig and editing .config to answer y to tulip support, the kernel =
>boots. It probes my ethernet card and calls it eth0. It also displays =
>its mac address and finds it on irq 10. However, the problem is that =
>when I check dev to make sure eth0 is present, it isn't there. Why would =
>the device not be initialized into a device file if it was probed =
>successfully? This doesn't really make sense to me, considering that =
>everything went ok. And naturally, I couldn't do ifconfig dhcp because =
>it didn't find the network interface? How could I go about fixing this =
>problem? Thanks in advance!=20
>
>
>_________________________________________________________
>Do You Yahoo!?
>Get your free @yahoo.com address at http://mail.yahoo.com
>
>
>_______________________________________________
>Speakup mailing list
>Speakup at braille.uwo.ca
>http://speech.braille.uwo.ca/mailman/listinfo/speakup