Hardware Question

[Alex Snow]

Hi.
Thanks for the quick response!
Yup.  Thats the way the cdrom looks.  Only problemis, The three sets of
jumpers don't have any of those jumper things on them.  They just are three
sets of 2 pins.
Found it on the hd thou.
----- Original Message -----
From: "Kerry Hoath" <kerry at gotss.net>
To: <speakup at braille.uwo.ca>
Sent: Thursday, March 07, 2002 8:34 PM
Subject: Re: Hardware Question


> I've posted on this before but here we go again:
> With the connectors of the cdrom towards you you have:
> power on the right, 4-pin.
> IDE ribbon connector 40-pin
> then a jumper block then redbook audio then digital out and mode jumpers
working your way to the left.
> The jumper pins closed to the 40-pin ribbon cable is master,
> the next set are slave and the next set are cable select.
> If there is a secondary ide controller put the cdrom on that since
> some hard drives have different jumperings for single drive
> and drive with slave especially western digital.
> Otherwise cdrom as slave is on the center of the set of 3 jumpers next to
the ribbon.
>
> Regards, Kerry.
> On Thu, Mar 07, 2002 at 06:57:07PM -0500, Alex Snow wrote:
> > Hi.
> > I am installing a temperary verson of linux on an old 486 box.  To Get
linux from the winblows machine to the 486, I need to install a CDrom.  I
hooked it to the same ribbon as the hd since there was room, but it won't
boot with the cdrom on the controler.  How do I tell the hd to be master and
cdrom to be slave?
> --
> Kerry Hoath:  kerry at gotss.net kerry at gotss.eu.org or
kerry at gotss.spice.net.au
> ICQ: 8226547 msn: kerry at gotss.net Yahoo: kerryhoath at yahoo.com.au
>
> _______________________________________________
> Speakup mailing list
> Speakup at braille.uwo.ca
> http://speech.braille.uwo.ca/mailman/listinfo/speakup
>