espeakup

[Mark Peveto]

Well, it's sure worth a try.  I'll get started.

Mark Peveto
Registered Linux user number 600552
Sent from vinux using alpine 2.20.10


On Thu, 26 May 2016, Willem Venter wrote:

> Hi.
> Pulseaudio takes complete control of the audio device, so when other
> devices try to use the soundcard through alsa things break.
>
> A work around I use is playing sound using dmix. This means a bit more
> processing and possibly a little latency for programs using pulse, but
> on the other hand it's better than broken sound.
>
> Remove package pulseaudio-alsa, which provides compatibility layer
> between ALSA applications and PulseAudio. After this your ALSA apps
> will use ALSA directly without being hooked by Pulse.
> Edit /etc/pulse/default.pa.
> Find and uncomment lines which load back-end drivers. Add device
> parameters as follows. Then find and comment lines which load
> autodetect modules.
> load-module module-alsa-sink device=dmix
> load-module module-alsa-source device=dsnoop
> # load-module module-udev-detect
> # load-module module-detect
>
> After rebooting pulseaudio won't grab the sound device, but instead
> plays it through dmix.
>
> hth
> Willem
>
> On 5/26/16, Mark Peveto <southernprince73 at gmail.com> wrote:
> > Here's the error I was talking about earlier.
> >
> > Back story:  I'm trying to get console speech.  Since i can't right now,
> > I'm doing this from a terminal, which reads badly. Once I type sudo
> > espeakup, it'll read the top of the console screen, and the login prompt
> > asking for a username.  After that it gives an error which i'll post.  I
> > know it's a pulseaudio problem.  Most suggest I get rid of pulseaudio,
> > and if that's the only solution there is, I guess i'll have to, but that
> > creates more problems when it comes to having the system rediscover new
> > sound drivers.  Long explanation short, it jacks things up!
> >
> > Error follows.
> >
> > [southernprince at roxie ~]$ sudo espeakup
> > [sudo] password for southernprince:
> > [southernprince at roxie ~]$ Assertion 'p' failed at pulse/simple.c:273,
> > function pa_simple_write(). Aborting.
> >
> > It should be noted here that the error does not appear until I start to
> > type.  It reads the login prompt, and once i hit the s for
> > southernprinc, my username, the error appears.  If I could figure out
> > how, I might turn keyecho off, which I wanna do anyway, but I don't know
> > if that'd help anything.
> >
> > There ya have it folks.
> >
> > _______________________________________________
> > Speakup mailing list
> > Speakup at linux-speakup.org
> > http://linux-speakup.org/cgi-bin/mailman/listinfo/speakup
> >
> _______________________________________________
> Speakup mailing list
> Speakup at linux-speakup.org
> http://linux-speakup.org/cgi-bin/mailman/listinfo/speakup
>