Pulse Audio

[Robert Spangler]

they were all commented on mine by default on Debian Sid.


On 3/10/2014 1:19 PM, Janina Sajka wrote:
> Yes, if it's commented, absolutely. Uncomment it.
>
> I simply don't recall what the default state of that config file is. I
> suppose I could go get an untweaked copy, but such wasn't immediately at
> hand today.
>
> Janina
>
> Robert Spangler writes:
>>
>> On 3/10/2014 10:58 AM, Janina Sajka wrote:3.)	Make sure the TTS you
>> want is correctly specified. I made sure
>> espeak was uncommented:
>>
>> DefaultModule espeak
>>
>> It is also necessary to uncomment the appropriate line to add the
>> module, correct?
>>
>> I find Pulse Audio to add yet another layer of irritation to my
>> sound system, so if I can get your method to work, it is preferred.
>>
>> Thanks,
>> Robert
>> On 3/10/2014 10:58 AM, Janina Sajka wrote:
>>> Robert Spangler writes:
>>>> I even tried Janina's suggestion of disabling Pulseaudio (using her
>>>> steps) and that just resulted in Orca not speaking.
>>>>
>>>
>>>
>>> Oh, and one more thing ...
>>>
>>> You have to edit /etc/speech-dispatcher/speechd.conf
>>>
>>> You need at least:
>>>
>>> 1.)	Set alsa as your environment. SD defaults to pulse. Change that.
>>> the file shows you how.
>>>
>>> 2.)	Double check that you're correctly specifying the also device
>>> you want to drive. On my old Lenovo laptop this currently reads:
>>>
>>> AudioALSADevice "plughw:0,0"
>>>
>>> 3.)	Make sure the TTS you want is correctly specified. I made sure
>>> espeak was uncommented:
>>>
>>> DefaultModule espeak
>>>
>>>
>>> hth
>>>
>>> Janina
>>>
>>> _______________________________________________
>>> Speakup mailing list
>>> Speakup at linux-speakup.org
>>> http://linux-speakup.org/cgi-bin/mailman/listinfo/speakup
>>>
>> _______________________________________________
>> Speakup mailing list
>> Speakup at linux-speakup.org
>> http://linux-speakup.org/cgi-bin/mailman/listinfo/speakup
>