Hardware synths, specifying port
Mike Ray
mike at raspberryvi.org
Wed May 29 17:49:22 EDT 2013
Hello Gregory,
That might be a problem for the Raspberry Pi as I am using a PL2303 USB
to serial converter and the serial port this creates is /dev/ttyUSB0.
So I don't think this will work with the Dolphin Juno I have.
Mike
On 29/05/2013 22:29, Gregory Nowak wrote:
> Mike,
> you would do something like:
>
> modprobe speakup_apollo ser=0
>
> where 0 is the first serial port, 1 is the second, and so on. HTH.
>
> Greg
>
>
> On Wed, May 29, 2013 at 03:55:43PM +0100, Mike Ray wrote:
>> Hello folks,
>>
>> How do I specify the port to be used by a hardware synth?
>>
>> For example if I'm using the Apollo module, how do I get it to use a
>> specific port?
>>
>> Mike
>>
>> --
>> Michael A. Ray
>> Analyst/Programmer
>> Witley, Surrey, South-east UK
>>
>> Interested in accessibility on the Raspberry Pi?
>> Visit: http://www.raspberryvi.org/
>>
>> From where you can join our mailing list for visually-impaired Pi hackers
>>
>> _______________________________________________
>> Speakup mailing list
>> Speakup at linux-speakup.org
>> http://linux-speakup.org/cgi-bin/mailman/listinfo/speakup
>>
--
Michael A. Ray
Analyst/Programmer
Witley, Surrey, South-east UK
Interested in accessibility on the Raspberry Pi?
Visit: http://www.raspberryvi.org/
From where you can join our mailing list for visually-impaired Pi hackers
More information about the Speakup
mailing list