three hds? is this possible?

[Littlefield, Tyler]

ok. I got my 20 gb set to master. For the bios settings, do I just set it
under cd? or where do I need to change it at?
Thanks,
----- Original Message ----- 
From: "Doug Sutherland" <doug at proficio.ca>
To: "Speakup is a screen review system for Linux." <speakup at braille.uwo.ca>
Sent: Thursday, May 17, 2007 7:01 PM
Subject: Re: three hds? is this possible?


> On most IDE motherboards you have two IDE controllers,
> each can support one master and one slave on a single cable.
> You may need to set jumpers on the actual drives to get them
> set up correctly, one jumpered as master, one jumpered as
> slave on each controller.
>
> The jumper setting info will be labeled on the drives.
> You may also need to check the BIOS settings and make
> sure that all four drives are enabled, and on older BIOS you
> may need to set them to the correct setting for the drive,
> while on newer BIOS usually setting them all to AUTO will
> auto-detect the drives and configure the BIOS appropriately.
>
>   -- Doug
>
> _______________________________________________
> Speakup mailing list
> Speakup at braille.uwo.ca
> http://speech.braille.uwo.ca/mailman/listinfo/speakup