speech-dispatcher rate and volume settings for espeak 1.25

[William Hubbs]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

On Sun, Jun 03, 2007 at 11:38:49PM +0200, Hermann wrote:
> OK, what result do you expect? Is the synth too loud or too low?

The speech from

espeak "This is a test."
and
spd-say "This is a test."

should have the same volume.  I was just wondering if anyone on the list
had figured out what the proper  "genericVolumeAdd" and
"genericVolumeMultiply" values are to make that happen.

> Or you can try to change the values in the GenericExecute string in 
> espeak-generic.conf. Instead of $VOLUME you can try to insert a specific 
> value.

I really don't want to do this, because if I can get the values right, I
want to set it up that way for the gentoo distribution.

Thanks,

- -- 
William Hubbs
gentoo accessibility team lead
williamh at gentoo.org
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.7 (GNU/Linux)

iD8DBQFGY0dGblQW9DDEZTgRAtZNAKCPtSRpYCy/v6Sg7pGAfUGra9/fCACdH5Nz
MG8nKChxqWU8nWi7hc37jfs=
=5LKF
-----END PGP SIGNATURE-----