Starting GRML

[Sina Bahram]

Well, first of all, when the boot screen comes up, you type swspeak
 
Try counting to 15 after you turn on the computer, since it'll probably take
about 5 or so seconds for your bios, and that will give you some lee way ...
After you type swspeak and hit enter, then wait for about a minute or two
... Until you get to the prompt, at which point you type speechd-up

Take care,
Sina

-----Original Message-----
From: speakup-bounces at braille.uwo.ca [mailto:speakup-bounces at braille.uwo.ca]
On Behalf Of ace
Sent: Saturday, April 08, 2006 11:45 AM
To: speakup at braille.uwo.ca
Subject: Starting GRML

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Hello folks,

I know that the commands to start GRML are:
grml swspeak
speechd-up

I, however, cannot get it to start.  I am sure that there is a specific part
in the boot process where I need to type these commands.  How do I know when
I need to type them?  

Thanks,
Robby
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.2 (GNU/Linux)

iD8DBQFEN9qDwamDI1Gy2GIRAtqXAKC755zYC3AVqnF8SFaqyr/U1Ts2hACg5oBN
J7vrzDCx+fUoKHGR3HetdJc=
=juXt
-----END PGP SIGNATURE-----

_______________________________________________
Speakup mailing list
Speakup at braille.uwo.ca
http://speech.braille.uwo.ca/mailman/listinfo/speakup