speakup.s

[randy turner]

hi Stephen,
that command works with the speakup.i
but on my system it does not work
with the speakup.s
for some reason.
is there anyway to use just one floppy
to boot up from the cdrom?
when i use the command
ramdisk speakup_synth=dtlk
with speakup.s the system boots but i get no speech at all.
i can't figure out why it would work with speakup.i
and not with speakup.s on my system.
thanks in advance
randy


On Fri, 11 Feb 2005, Stephen Clower wrote:

> Hello Randy,
>
>     Yes, that command will work if you're using the Speakup.s kernel on a floppy. However, if you have access to a normal CD-ROM based installation, here's a quicker and easier way to get the process going. Put the first Slackware CD into your CD-rom drive and boot up your computer. When the disk stops spinning, type:
> speakup.s speakup_synth={synth_name}
>
> HTH
> Steve
>
>
> On Friday, February 11, 2005, 3:19:37 PM, you stood on a roof and loudly proclaimed:
>
>
>> hi all,
>> is the ramdisk command for speakup.s
>> the same as it is for speakup.i?
>> after the floppy stops i inter this
>> "ramdisk speakup_synth=dtlk"
>> with the speakup.i that works
>> but not with the speakup.s
>> thanks in advance.
>> randy
>
>
>> _______________________________________________
>> Speakup mailing list
>> Speakup at braille.uwo.ca
>> http://speech.braille.uwo.ca/mailman/listinfo/speakup
>
>
> ----------
> Stephen Clower
> Email/.Net Messenger: steve at steve-audio.net
> AIM: AudioRabbit03
> Skype: sclower
>
> Check out my little home on the web at http://www.steve-audio.net
>
>
> _______________________________________________
> Speakup mailing list
> Speakup at braille.uwo.ca
> http://speech.braille.uwo.ca/mailman/listinfo/speakup
>