braille blazer

Danny Crone dannyboy at pobox.com
Fri Sep 12 19:58:20 EDT 2003


The blazer did work when I was in root.  I typed
cp stuff.brf /dev/lp0
and the blazer worked.  But it sent two blank pages out, after 
embossing.

On Fri, 12 Sep 2003, Luke 
Davis wrote:

> Also, are you certain that you really have a parallel port?
> I mean, is it enabled in the CMOS, and if you go through /proc/ioports,
> /proc/interrupts, and so on, do you see it?
> 
> 
> On Thu, 11 Sep 2003, Danny Crone wrote:
> 
> > No matter what I do, I cannot get the blazer to print.  When using
> > /dev/lp0 the system says that there is no device.  How should I set linux
> > up to know there is something on lpt1?  Also, is that equal to lp0?
> >
> >
> > _______________________________________________
> > Speakup mailing list
> > Speakup at braille.uwo.ca
> > http://speech.braille.uwo.ca/mailman/listinfo/speakup
> >
> 
> _______________________________________________
> Speakup mailing list
> Speakup at braille.uwo.ca
> http://speech.braille.uwo.ca/mailman/listinfo/speakup
> 
> 





More information about the Speakup mailing list