usb mass storage question

[Gregory Nowak]

Hi all.

I just got from a friend one of those things that you can put an ide
drive into, and hook it up to the usb port. He gave me a hard drive
too.

I enabled in the kernel usb section the 2 different choices that there
are for an atapi to usb bridge, and loaded the usb-storage module.
It tells me though after I turn on the usb hard drive thing that the
product and vendor id is not claimed by any active driver.
My /proc/bus/usb/devices is below.

T:  Bus=01 Lev=00 Prnt=00 Port=00 Cnt=00 Dev#=  1 Spd=12  MxCh= 2
B:  Alloc=  0/900 us ( 0%), #Int=  0, #Iso=  0
D:  Ver= 1.00 Cls=09(hub  ) Sub=00 Prot=00 MxPS= 8 #Cfgs=  1
P:  Vendor=0000 ProdID=0000 Rev= 0.00
S:  Product=USB UHCI-alt Root Hub
S:  SerialNumber=c000
C:* #Ifs= 1 Cfg#= 1 Atr=40 MxPwr=  0mA
I:  If#= 0 Alt= 0 #EPs= 1 Cls=09(hub  ) Sub=00 Prot=00 Driver=hub
E:  Ad=81(I) Atr=03(Int.) MxPS=   8 Ivl=255ms
T:  Bus=01 Lev=01 Prnt=01 Port=01 Cnt=01 Dev#=  3 Spd=12  MxCh= 0
D:  Ver= 1.00 Cls=ff(vend.) Sub=00 Prot=00 MxPS=64 #Cfgs=  1
P:  Vendor=03e8 ProdID=0015 Rev= 1.09
S:  Manufacturer=OnSpec Electronic Inc.
S:  Product=USB Disk
C:* #Ifs= 1 Cfg#= 1 Atr=40 MxPwr=  0mA
I:  If#= 0 Alt= 0 #EPs= 2 Cls=05(PID  ) Sub=00 Prot=00 Driver=(none)
E:  Ad=01(O) Atr=02(Bulk) MxPS=  64 Ivl=0ms
E:  Ad=82(I) Atr=02(Bulk) MxPS=  64 Ivl=0ms

Does anyone know if this is supported, and if so, what do I need to
configure to get it to be recognized?
BTW, I am using linux 2.4.21.

Thanks in advance for any help.

Greg


-- 
Free domains: http://www.eu.org/ or mail dns-manager at EU.org