kernel compiled successful but still more

Jacob Schmude jacobs at surferie.net
Wed May 7 18:40:46 EDT 2003


Hi
Did you make sure you compiled your drive's filesystem into the kernel? For 
instance if your drive is ext3, you need ext3 in the kernel, not as a 
module. Same goes for ext2 or reiserfs. If you're not sure which one your 
drive uses, you can safely compile all 3 in the kernel and refine it later.

At 18:15 5/7/2003 -0400, you wrote:

>                 okay so  here was the deal
>i did the horrid process of going through config
>i still had problems so then i looked a lot closer at the error messages i
>got from the make modules process.
>i turns out that apparently pcmcia and wan stuff is broken in 2.4.20
>so after i disabled pcmcia, wan and wireless just for the hell of it, it
>finally compiled properly
>so i installed the kernel
>i get through boot and the synth starts to talk and it says the following.
>kernel panic: VFS unable to mount r: oot FS on 03:01


More information about the Speakup mailing list