installing slackware 8.0 with speakup

[Gregory Nowak]

Well, that depends on your preference. If you want to boot from the hard drive, run "liloconfig" to set things up, and run "lilo" afterwords to install lilo to your hd. If you want to boot into windows right away like you're used to doing, then boot linux from a floppy.
Greg


On Sun, Jan 13, 2002 at 12:33:59PM -0600, Reinhard Stebner wrote:
> well, that did it!!!  Should I leave the system booting from a floppy?
> Thanks for your help.  I guess now comes the fun part of learning my new
> system right?
> 
> ----- Original Message -----
> From: "Gregory Nowak" <gnowak1 at uic.edu>
> To: <speakup at braille.uwo.ca>
> Sent: Sunday, January 13, 2002 12:13 PM
> Subject: Re: installing slackware 8.0 with speakup
> 
> 
> > In that case, try something like:
> > "mount speakup_synth="xxxx where xxxx is your synth. Notice that the only
> thing replaced here is linux with mount.
> > Greg
> >
> >
> > On Sun, Jan 13, 2002 at 11:20:40AM -0600, Reinhard Stebner wrote:
> > > I am trying to boot from the boot floppy I made during the install.  If
> I
> > > have the disk out, the system will boot windows.
> > >
> > >
> > > _______________________________________________
> > > Speakup mailing list
> > > Speakup at braille.uwo.ca
> > > http://speech.braille.uwo.ca/mailman/listinfo/speakup
> >
> > _______________________________________________
> > Speakup mailing list
> > Speakup at braille.uwo.ca
> > http://speech.braille.uwo.ca/mailman/listinfo/speakup
> >
> 
> 
> _______________________________________________
> Speakup mailing list
> Speakup at braille.uwo.ca
> http://speech.braille.uwo.ca/mailman/listinfo/speakup