ide-scsi emulation for zip drive, should I be worried
Gregory Nowak
greg at romuald.net.eu.org
Fri Dec 27 16:09:47 EST 2002
Hi all.
I just enabled ide-scsi emulation for my 250 mb ide-atapi zip drive. Everything works, but I get the following in my dmesg output.
hdd:<3>ide-scsi: hdd: unsupported command in request queue (0)
end_request: I/O error, dev 16:40 (hdd), sector 0
ide-scsi: hdd: unsupported command in request queue (0)
end_request: I/O error, dev 16:40 (hdd), sector 2
ide-scsi: hdd: unsupported command in request queue (0)
end_request: I/O error, dev 16:40 (hdd), sector 4
ide-scsi: hdd: unsupported command in request queue (0)
end_request: I/O error, dev 16:40 (hdd), sector 6
ide-scsi: hdd: unsupported command in request queue (0)
end_request: I/O error, dev 16:40 (hdd), sector 0
ide-scsi: hdd: unsupported command in request queue (0)
end_request: I/O error, dev 16:40 (hdd), sector 2
ide-scsi: hdd: unsupported command in request queue (0)
end_request: I/O error, dev 16:40 (hdd), sector 4
ide-scsi: hdd: unsupported command in request queue (0)
end_request: I/O error, dev 16:40 (hdd), sector 6
unable to read partition table
Later on I get:
SCSI subsystem driver Revision: 1.00
scsi0 : SCSI host adapter emulation for IDE ATAPI devices
Vendor: IOMEGA Model: ZIP 250 Rev: 51.G
Type: Direct-Access ANSI SCSI revision: 00
Vendor: HP Model: CD-Writer+ 9100 Rev: 1.0c
Type: CD-ROM ANSI SCSI revision: 02
Attached scsi removable disk sda at scsi0, channel 0, id 0, lun 0
sda : READ CAPACITY failed.
sda : status = 0, message = 00, host = 0, driver = 28
Current sd00:00: sns = 70 2
ASC=3a ASCQ= 0
Raw sense data:0x70 0x00 0x02 0x00 0x00 0x00 0x00 0x12 0x00 0x00 0x00 0x00 0x3a 0x00 0x00 0x00 0x00 0x00 0xff 0xfe 0x01 0x05 0xf1 0x01 0xce 0x69
sda : block size assumed to be 512 bytes, disk size 1GB.
sda: I/O error: dev 08:00, sector 0
I/O error: dev 08:00, sector 0
unable to read partition table
Attached scsi CD-ROM sr0 at scsi0, channel 0, id 1, lun 0
sr0: scsi3-mmc drive: 32x/32x writer cd/rw xa/form2 cdda tray
Uniform CD-ROM driver Revision: 3.12
Is this normal, or am I missing something?
Thanks.
Greg
More information about the Speakup
mailing list