Speakup V0.09 & new kernel 2.2.16...no talkie

[Jacob Schmude]

Hi
	Add speakup_ser=1 to the kernel command line. This will force
speakup to look on ttyS1. My guess is that it's finding that modem and
attempting to use it as a synth. Of course, no response from the modem, so
no speech.


On Sat, 1 Jul 2000, Buddy Brannan wrote:

> Hey y'all,
> 
> Well, because somehow I managed to screw up my previous kernel source tree
> (patching to 2.2.16 and then Speakup, it didn't go very well, but it's
> probably because I forgot I did something--or forgot to do something), I
> downloaded a new complete 2.2.16 tarball, untarred it, patched in Speakup
> V0.09A (Yes, I used the correct patch file), configured it--I lost my
> original old .config, so I started it over--installed it--rebooted--and no
> speech. 
> 
> I have the Accent SA on /dev/ttyS1 and wonder if it's not detecting there
> for some reason? I have a modem (external, switched on) on /dev/ttyS0...I
> haven't tried booting with the modem switched off. I think I shall try
> this. In any case, how do you force Speakup to use a particular serial
> port--I don't exactly recall.
> 
> Thanks.
> 
> 
> -- 
> Buddy Brannan, KB5ELV        | And if the ground yawned,
> Email: davros at ycardz.com     | I'd step to the side and say,
> Phone: (972) 276-6360        | "Hey ground! I'm nobody's lunch!"
> Voice mail: (877) 791-5298   | --Eddie From Ohio
> 
> _______________________________________________
> Speakup mailing list
> Speakup at braille.uwo.ca
> http://speech.braille.uwo.ca/mailman/listinfo/speakup
> 
>