alsa broken after 2.2.18 upgrade

[Charles Hallenbeck]

Jim,
Thanks for the response... I tried your procedure with the same error
message resulting. My card is an sblive so I selected "emu10k1" which I
believe is what I needed to do.
I guess I will go get some coffee, and think about taking up photography
or something...
Chuck


 On Wed, 13 Dec 2000, Jim Danley wrote:

> Yesterday I upgraded to 2.2.18 and experienced the same error as you when
> compiling the alsa driver.  Thanks to suggestions from Kirk and Frank,
> I was finally able to compile cleanly.  Here are the steps that I took.
> Perhaps they will work for you as well.
> 
> completely remove the alsa driver directory and its contents
> (rm -r alsa-driver-0.5.9d)
> 
> re-install from the file archive
> (bunzip2 -c alsa-driver-0.5.9d.tar.bz2 | tar xf -)
> 
> change to the alsa-driver-0.5.9d directory and run configure with the
> --with-cards= option.
> 
> By default, ./configure sets things up so you can compile and install
> ALL of the drivers and you only really need to install the driver for
> your particular sound card.
> 
> I ran (./configure --with-cards=cs4236)
> 
> then run:
> make
> make install
> 
> and you should be well on your way.  Now, if your sound card happens to
> be a wavefront ... write to the developers.  Good luck.
> 
> 	Jim
> 
> On Wed, Dec 13, 2000 at 09:00:57AM -0500, Charles Hallenbeck wrote:
> > ... upgrading from
> > 2.2.17 to 2.2.18, I get a compile error while compiling "alsa-drivers
> > v0.5.9d" ...
> > wavefront.c: In function `wavefront_wait':
> > wavefront.c:303: structure has no member named `loops_per_sec'
> > make[2]: *** [wavefront.o] Error 1
> 
> _______________________________________________
> Speakup mailing list
> Speakup at braille.uwo.ca
> http://speech.braille.uwo.ca/mailman/listinfo/speakup
> 

My web site is http://www.mhonline.net/~chuckh 
The reverse side also has a reverse side.  
		-- Japanese proverb